Termékek pla kemény (5)

FLAME RETARDANT FOR PLASTICS

AQUA Pe - monofile Polyethenbürsten Diese Polyethylenbürste werden gerne in LKW Waschanlagen verwendet, wo sie für eine optimale Reinigung für den LKW aber genauso für den für den PKW sorgt.

PEEK (Polyetheretherketon) ist ein teilkristalliner, thermoplastischer Kunststoff mit hervorragenden Gleiteigenschaften ...

La Perla Maiskolben (4 Stück), Vakuum Pack, 1.062 ml Der Anbieter stellt keine detailierte Produktbeschreibung zur Verfügung. GRÖSSE:1.062 ml MARKE:La Perla SORTE:Maiskolben 4 Stück, Vakuum Pack UMVERPACKUNG:12

In the injection moulding process TPE pellets are fed into the machine through a hopper and then into a heated barrel. The heat from the barrel turns the material into a liquid resin which is then injected into a closed mould under high pressure. After allowing the molten polymer to cool, the finished part can be removed from the mould. Injection moulding is a high-volume, high tooling cost process, the advanced properties of our TPE compounds deliver short cycle times allowing parts to be produced at a rapid rate. The information below is intended as a general overview, settings may vary depending on the specific grade selected. Please CONTACT US for detailed processing information Settings Equipment Conventional injection moulding machine Compression set At least 2:1. Special screws with short sections and higher compression ratios (3:1 to 4:1) may be good at low screw speeds Shrinkage Between 1.0% and 2.5% depending on the grade, type of application and location of the gate. Moul